ToolTag

CAD 3D render of StealthTag airtag tracker case

Keep track of the things that matter to you

Keep track of gear that matters.

Introducing ToolTag – the perfect solution for safeguarding your tools, equipment and personal belongings. Built with precision using 3D printing technology, ToolTag provides a discreet and inconspicuous case for your Apple AirTag Bluetooth tracker. This innovative accessory allows you to track your valuables effortlessly. Keep track of your gear and in your hands where it belongs.

ToolTag can be applied to your power tools, toolbox, snowboard, kiteboard, motorbike, car, e-scooter, boat, trailer, camera hard case, suitcase or luggage. The possibilities are endless! Why not use a ToolTag on the inside of your travel case? Just find a hard flat surface and you can track your bags during your travels from start to finish!

Single ToolTag

Pack of 3 ToolTags

Installation

The ToolTag can be attached to most hard surfaces. Just follow these simple steps to attach your ToolTag.

Clean the hard surface to which you wish to attach the ToolTag to remove any dirt, dust, and grease. Using isopropyl alcohol is very good for this.
Peel off the backing of the sticky pad and place the ToolTag where you want it to go.
Push firmly to make sure the pad is fully stuck.
Full bonding can take up to 48hrs so try your best to resist the urge to pull it to see if it is stuck!
That’s it! Now place your Airtag inside and you can start tracking your item. Note: When installing the Airtag, it goes silver side down as per the photo below.